Leveling a Rolling Door
COPYRIGHT 2000 G.G. ALONZY
My problem is keeping our patio screen door level. My lovely wife has a fit when the door doesn't slide smoothly. I hate trying to level the door but since I hate my wife's yelling and hollering more I muddle through. I have the typical screen door where you adjust the wheels with the screws over the wheels. Is there some secret to doing it easily?
The only secret I have discovered is that most rolling door problems... whether it be screen doors, garage doors or shower doors... are usually traced to degeneration in the rollers themselves, not the skills of the adjuster! I have played that game myself... adjust and adjust until you want to drive your fist through the screen. Calm, NH... deep breaths... better now...
Remove the door and look at the rollers. If they are plastic, look for broken edges. If the rollers are metal, look for bent or rough edges... the metal rollers generally don't break. Is the mounting assembly bent or are the rollers binding on the shaft? If any of these conditions exist, put away the silicone spray or the WD-40 and replace ALL of the rollers... top and bottom. That is, unless the top rollers are nonexistent (some sliding screens use a guide instead of a roller on top) or in pristine condition. This may solve your problem.
May? It is also possible that your problem lies not with the hardware but with the patio door frame. Settlement in the door frame or poor initial installation can make perfect or even "just adequate" adjustment a hopeless task. So if everything else seems OK, make a few vertical measurements between the top and bottom tracks. Does the center of the track measure less than the ends? This would cause binding that adjustment might not be able to compensate for. Is the frame square? Measure across both "opposite corners"... upper left to lower right and versa visa. If these two measurements are not nearly identical, the frame is not a rectangle but a parallelogram. This means that the top and bottom tracks are closer together than they should be... another condition that can cause binding.
These last few heartbreakers are not simple to repair. The mouldings around the frame would have to be removed to see why the frame is distorted. The frame would have to be cut loose on the top and sides and repositioned in correct alignment to the bottom track. Depending on the age of your door set and the condition of the glass (foggy insulated glass, perhaps?) sometimes the best solution is to just replace the whole gosh-darned thing. The labor for a repair of this sort can be nearly as high as installing a new set... sans materials, of course!
Have a small home repair question for THE NATURAL HANDYMAN? Just click here www.naturalhandyman.com/aitikia
For more home repair information, visit NH's growing list of original home repair articles and quality links www.naturalhandyman.com
If this information has been valuable to you, please consider making a small donation to support NH's free service to the home repair community! For more information, please visit our "Friends" page www.naturalhandyman.com/friends
The Natural Handyman Site Directory
- Home Repair Articles www.naturalhandyman.com/iip
- Home Repair Links Library www.naturalhandyman.com/linkslibrary
- NH's Bookshop www.naturalhandyman.com/bookshop
- Find a handyman at www.naturalhandyman.com/network
- Win unique home repair gifts and prizes at www.naturalhandyman.com/contest
Please read the important copyright and disclaimer information is located at www.naturalhandyman.com/copyright
Also in Home
- 5 ways your house can make you go broke
- 5 simple and affordable luxuries for your home
- 12 ways to lower heating bills
- Will my insurance spike if I rent out my basement?
- Why pay extra toward mortgage principal?
- 5 tips to sell a home before buying another
- 6 ways to stock your "man cave" for under $500
- 6 home projects that don't pay for themselves
- Should I refinance my home equity line?