-- Baby Boomers -- Family - -- Green -- Home and Auto -- -- In Critical Condition -- Lifestyle -- -- Just Starting Out -- Money -- |
Replacing a Bath Tub |
|
share your thoughts about frugal living at TDS Community Subscribe to Our Money Saving Newsletter Also In This Week's Issue Holiday revelers likely to rein in spending this year How would GM bankruptcy affect you? How did home values fare in your area? No-penalty CDs: Good deal or not? More Stories About: |
Home
Home and Auto
Home Repair
Bathrooms
Replacing a Bath Tub
Dear NH, Dear AA, Back to your question... yes, you can use a saw for this purpose. It's called a cut-off saw and has a very large diameter fibrous cutting blade to make cutting through the cast iron easier. Unless you plan on doing this job often, I suggest you rent one instead of purchasing it. Describe your cutting job to the salesperson to get the correct tool with the correct blade. Don't try to do this with a circular saw with a fibrous cutting blade... the job will take longer, many corners may be unreachable and you may burn out the saw's motor. First things first... you must disconnect the old drain from the tub. This will probably require you to cut into the ceiling below unless you are over an unfinished area such as a crawlspace or basement. Then you should remove any caulking that is holding the tub to the tiles or tileboard so it is not bonded to the walls. If you have ceramic tile it will be necessary to remove at least one row of tiles to install the new tub so you might as well do that now. If you have a tub surround or a type of tileboard, it can't be saved and will have to be cut to accommodate the new tub. By the way, I assume your tub is cast iron. If it is a fiberglass tub you can cut it with virtually any saw blade. The easiest and most versatile saw for this type of cutting is the reciprocating saw or "sawzall". Blades are available up to nearly a foot in length, making it easy to cut most anything. Just don't cut through the floor or your plumbing! Start with two cuts across the width of the tub, dividing the tub into thirds. Once the cuts are complete, you can remove the center piece. If it is still bound, it can be broken into pieces with a sledge hammer. Ditto with the end pieces. Don't go crazy with the sledge... just do what is necessary to remove the tub! Important: Cover the tub with a heavy tarp to keep pieces from flying around. Use eye protection, too! Because new and old tub dimensions may be different, you will have to do at least some wall work to install the new tub. If it is the same size as the old one, it may extend to the studs, not the finished walls, making it difficult to get in place without some persuading. If the new tub is smaller, fitting it will be a little easier. To fill the resulting gap, you can either 1) make a shelf to fill the gap (on the non-plumbing side) or 2) erect a floor-to-ceiling wall on either end of the tub. The floor-to-ceiling wall is really the better choice, especially if you also use the tub as a shower. The shelf will tend to collect water and be a leak waiting to happen! COPYRIGHT G.G. ALONZY Have a small home repair question for THE NATURAL HANDYMAN? Just click here www.naturalhandyman.com/aitikia
Take the Next Step
Do you have a time or money saving idea that wasn't included in this article? Please send it to tips @stretcher.com. We get the best ideas from our readers! Other Articles to Stretch Your Day and Your Dollar 10 Great Holiday Decorating Ideas!
Concrete Patios and Walkways
Estimating the Cost of Remodeling
How did home values fare in your area?
Broken Cabinet Hinges
Our Sponsor
Check Your Credit Now |
Copyright 1996 - 2008 "The Dollar Stretcher, Inc.". All rights reserved unless specifically noted.
Write to the Dollar Stretcher at:
Dollar Stretcher
PO Box 14160
Bradenton
FL 34280-4160
941-761-7805 voice
941-761-8301 fax
"The Dollar Stretcher, Inc." does not assume responsibility for advice given. All advice should be weighed against your own abilities and circumstances and applied accordingly. It is up to the reader to determine if advice is safe and suitable for their own situation.